Do you know these excavator fuel saving tips?

Excavator driving is the same as your own car. It is also able to pay attention to driving skills to save fuel, and it can also reduce the damage of excavator parts.

1. Don't do invalid actions

When the excavator is working repeatedly, some ineffective operation actions will cause 100% fuel consumption. As an excavator driver, he should design the operation according to the actual construction scene, adjust the height of the excavator, and try to prevent invalid actions.

2. Don't overload

The excavator has its own load specification. Excavating operations beyond the specified load will cause pressure loss and increase fuel consumption. Preventing the excavator from being overloaded can save a lot of fuel. If you don't believe it, try it.

3. Don't idling the engine

Liugong excavator parts excavators will "quietly" consume fuel when idling, for example: 1 set of 20 excavators work for 8 hours, even if idling for 1 hour will consume 20 kilograms of fuel! Therefore, do not let the engine be idling!

4. Decrease engine speed

When the excavator engine is operating at a high speed, the walking speed will also increase and the fuel consumption will increase. On the contrary, the fuel consumption when the engine is running at a low speed is relatively lower than that at a high speed.

5. Imported excavator accessories control stick operation scale

The depth of the excavator follows the operating scale of the boom and the bucket. If the operating scale of the stick's viewpoint can be adjusted to 30 degrees on the inside and 45 degrees on the far side, it can save fuel, instead of operating the stick to the end of the cylinder.

6. Reduce the operating point of view

There is also a more fuel-efficient method, which is to reduce the hovering point of view of excavators and loaders, and improve fuel efficiency by shortening the operation cycle.

7. Regularly clean up the soil

After each completion of the project, the soil sticking to the walking device should be cleaned up in time. If the soil is too much, it will invisibly increase the fuel consumption. Therefore, the excavator parts manufacturers remind the operators to form a good habit of regularly cleaning the walking soil.

8. Manipulate and explore viewpoints

When working with Kobelco excavator parts, do not adjust the elasticity of the stick to 90 degrees at the beginning of the operation. At this time, although the force of the cylinder to push the excavator is the largest, the fuel consumption is also high. If you adjust the operating point of the stick to 80 The fuel consumption will be relatively small if the temperature is about ℃.

9. Pay attention to the excavation sequence

Do you want to know how to save time, effort, and effort? Then remember to start work on both sides of the trench when digging the trench, and then dig the middle, master the excavation sequence, and easily reduce fuel consumption.

10. Digging in sections to reduce the scale of operations

During excavation operations, do not think that large-scale operations from the bottom to the top can improve work efficiency. On the contrary, if the scale of operations increases, the power of the excavator will decrease, and fuel consumption will increase. At this time, the method of excavation in upper, middle and lower sections should be adopted to save energy. Lots of oil.